S/C Black BLK-IPS102M Bedienungsanleitung PDF herunterladen (Seite 14)

www.sc-black.com

SECTION 2: INSTALLATION AND SETUP

Audio in/out wiring schematic

To connect a speaker and/or microphone to the camera:

1. Strip 1/4” of insulation from the microphone and speaker wires and insert them into the terminal

block in the pin locations shown in the terminal block gure above. Note that the common (ground)

leads of the microphone and speaker share the same terminal block pin.

CAUTION



Do not attach a headphone or earphone directly to the camera.

2.7.2 Sensor in (DI) connection

The camera provides one channel for sensor input that can be connected to either a voltage type or relay

type sensor. For voltage type sensors, the camera allows an input voltage range of 0 ~ 24 V DC, with

a 1 V DC threshold (see Specications). The conguration of the sensor input wiring is illustrated in the

following schematics.

CAUTION



Do not exceed the maximum input voltage or the relay switching rate. Refer to the

specications in this manual for more information.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Keine Kommentare

S/C Black BLK-IPS102M Bedienungsanleitung Seite 14